Ballast Water Treatment System

USCG Approved BWTS

TECHNOLOGY


ERMA FIRST BTWS FIT incorporates the most reliable and efficient filtration followed by a state of the art disinfection stage. Filtration takes place in either 40 microns automatic backwashing filters. The disinfection stage takes place in our own-design, highly customized electrodes, providing the appropriate amount of disinfectant agent by using minimum power and ensuring compliance. A special coating is applied on the electrodes, which are designed to minimize the production of harmful byproducts and have an extended life time of minimum 5000-6000hrs of operation.

 

OPERATION



 

    

BALLASTING

During ballasting, the water goes through the filter, where organisms and sediment with a diameter larger than 40 microns are separated and further discharged overboard, to their original habitat. The filtered water is then entering the Electrolytic Cell. From the chlorides of the water, free chlorine is produced through the process of electrolysis at very low concentration (4-6 mg/L). The treated water then, enters the vessel’s ballast tanks.





 

DE-BALLASTING

During de-ballasting, the system will only monitor the residual oxidants and will further intervene if necessary. The main stages of the system (filtration and disinfection) are bypassed. A chlorine sensor samples the residual chlorine at the discharge line. If this is greater than 0.1 mg/L, then it drives a dosing pump for the dosage of a neutralizing agent (Sodium Bisulfite). The successful neutralization of the free chlorine is confirmed by a second chlorine sensor, installed at the far end point of the ballast discharge line.